Glacier bay BZ551000BN Guía De Uso Y Cuidado

TOOLS REQUIRED
Phillips Flathead
screwdriver screwdriver
Installation
1
Determining the mounting
location
Determine the location where you wish to
install your accessory.
Place the mounting bracket (BB) at the
desired location and mark the installation
holes using a pencil.
AA
USE AND CARE GUIDE
TOWEL RING
Electric drill Pencil
2
Drilling the pilot hole
Pre-drill a pilot hole with a small drill.
Safety Information
If installing into ceramic tile, before
attempting to drill through ceramic tile,
the following must be done:
Using a center punch, very lightly and
carefully tap the spot where you wish to
drill to break the shiny glass portion of
the tile.
HARDWARE INCLUDED
AA-Mounting bracket x1
Claw
CC-Set screw x1
hammer
3
1
Please contact 1-855-HD-GLACIER for further assistance.
Item #000-000
Model #BZ551000BN
OMSID #305556534
BB-Mounting screw x2
DD-Solid wall anchor x2
Installing the brackets in ceramic
tile
Drill 1/4 in. based on the pre-drill pilot hole.
Tap 1/4 in. solid wall anchors (DD) into the wall
with a hammer until flush with the wall.
Align the mounting brackets (AA) with installed
solid wall anchors (DD) and secure with the
mounting screws (BB).
DD
DD
AA
HOMEDEPOT.COM/GLACIERBAY
BB