Glacier bay BTB01100RW Guía De Uso Y Cuidado

TOOLS REQUIRED
Phillips Electric drill
screwdriver
Installation
1
Determining the mounting
location
Determine the location where you wish to
install your accessory.
Place the mounting bracket at the desired
location and mark the installation holes
using a pencil.
Pencil Claw
hammer
2
Installing the bracket in
drywall
Drill a 1/8 in. pilot hole at each pencil
mark made.
Drive the E-Z Ancor into the wall using
®
a Phillips screwdriver until flush with
the wall.
Align the mounting brackets with the E-Z
Ancor and secure with the mounting
®
screws.
NOTE: To install the bracket in a wood stud,
proceed to Step 3. To install the bracket in
ceramic tile, proceed to Step 4.
1
USE AND CARE GUIDE
HARDWARE INCLUDED
E-Z Ancor x4 Mounting bracket x2
®
Hex wrench x1 Set screw x2
3
Installing the bracket in a
wood stud
Drill a 3/32 in. pilot hole at each pencil
mark made.
Align the mounting brackets with pilot
holes and secure with the mounting
screws.
Please contact 1-855-434-5224 for further assistance.
Item #591-205
596-776
Model #BTB01100RW
BTB01200RW
TOWEL BAR
Mounting screw x4
HOMEDEPOT.COM