MAC Audio MPExclusive 1.0 XL El Manual Del Propietario página 9

FIG. 1 POWER SUPPLY / REMOTE SWITCH-ON CONNECTION
(1) GND terminal for the ground, to the battery's minus pole
(2) REM terminal for remote switch-on
(3) Terminal for +12 V battery voltage
(4) Battery
(5) Cable fuse
(6) To your car radio's automatic aerial connection
If your car is not equipped with an automatic aerial connection, connect this cable's plus pole (+) to the ignition lock. An on/off switch
should be inserted in this case. Make sure that this switch is switched off if the amplifier is not used.
FIG. 2 OPERATION WITH STEREO CAR RADIO
Connect and set the amplifier as shown in Fig. 2 if it is to be controlled by a car radio with two output channels. Operation of the low-pass
filter used is described in Chapter 5.2.
(1) To the car radio, left output
(2) To the car radio, right output
(3) Subwoofer
FIG. 3 OPERATION WITH ONE CAR RADIO WITH SUBWOOFER OUTPUT
(1) To the car radio, subwoofer output
(2) Subwoofer
FIG. 4 USE AS A SUBWOOFER AMPLIFIER WHILE USING AN ADDITIONAL 4-CHANNEL AMPLIFIER (MPEXCLUSIVE 4.0 /
MPEXCLUSIVE 4.0 XL) FOR 4 SATELLITE LOUDSPEAKERS
(1) To the car radio, front left output
(2) To the car radio, front right output
(3) To the car radio, rear left output
(4) To the car radio, rear right output
(5) Front left loudspeaker
(6) Front right loudspeaker
(7) Rear left loudspeaker
(8) Rear right loudspeaker
(9) Subwoofer
FIG. 5 OPERATING ELEMENTS AND IN/OUTPUTS
(1) Connection for volume remote control
(2) Bass-booster control
(3) Cross-over frequency control for the subsonic filter
(4) Transfer frequency control for low pass
(5) Input level control
(6) Outputs for connecting other amplifiers
(7) Low-level input
(8) Remote Control
9