Use Of The Bicycle; Braking And Safety Systems - Cicli Esperia E230U BOURGET Manual De Uso

4.

Use of the bicycle

D
4.1. To turn on the bicycle press the power button located on the battery and
subsequently the one on the controller to the handlebar.
A. ON/OFF: Press and hold the button
and hold the same button for 2 seconds.
If the bike is not used for 10 minutes, the controller turns off automatically. To turn it
back on, press the power button.
B. ASSISTANCE MODE: when the controller is switched on the assistance of the
motor is at level 1 (minimum motor assistance, maximum battery life).
Press the "+" o "-" button to change the pedal assist motor power. The higher power
is 4 (maximum motor assistance, minimum battery life).
At level 0 the bicycle runs without motor assistance.
C. TURNING ON THE LIGHTS: Press the button
system. Do the same to switch it off.
D. WALK ASSIST: press and hold for 2 seconds the button "-" to activate the walk
assisted mode (speed 6 km/h).
E. BATTERY STATUS: the status of the battery can be read on the led indicator
located below "POWER". When the battery is fully charged all the leds will be lit.
As the battery discharges the number of leds on progressively decreases. When
the battery is fully discharged, a single led, above the label "LOW", informs the user
about the necessity to urgently recharge the battery.
5.

Braking and safety systems

5.1. This bicycle model is equipped with a v-brake system.
WARNING: efore riding on a public road, we suggest you become familiar with the
braking system. Uncontrolled use of brakes can cause serious risks to your safety.
Remember that the left lever activates the front wheel brake while the right one the
rear wheel brake.
B
to turn on the controller. To turn it off press
E
C
A
to switch on the lighting
85