Installing The Batteries - TRT DTK 4300 Manual De Instrucciones

12.
CHANNEL or buttons–
sired channels for viewing or recording.
Tracking function–
(lines or dots on screen) during playback or slow
mode.
Press to stabilize the picture in the Still mode when
the picture begins to vibrate vertically.
13. RECORD button– Press for manual recording.
OTR button– Press to activate One Touch Record-
ing. (only on the VCR)
14. Press to display the menu on the TV
MENU button–
screen. Press to exit the menu on the TV screen.
15. NUMBER buttons– Press to select desired channels
for viewing or recording. To select channels from 1
to 9, first press "0" button then 1 to 9. (only on the
remote control)
When selecting cable channels which
+100 button–
are higher than 99, press this button first, then press
the last two digits. (To select channel 125, first press
"+100" button then press "2" and "5"). (only on the
remote control)
16. Press to display the current time,
DISPLAY button–
channel number, real time tape counter, and other infor-
mation on the TV screen. (only on the remote control)
Each time you press this button, TV screen will
change as shown. The status display (STOP, PLAY
etc.) and the tape speed display (SP, LP (playback
only), or SLP) will disappear after 5 seconds.
<OFF mode> <COUNT mode>
Press
once
17.
SLOW button– Press to start slow motion playback.
(only on the remote control)
18.
COUNTER MEMORY button–
memory on and off.(only on the remote control)
H7842
All manuals and user guides at all-guides.com
Press to select the de-
Press to minimize video 'noise'
<CLOCK mode>
5:40PM
STOP STOP
CH 02
Press
once
SP 0:12:34 SP
Press once
Press to set counter
19.
COUNTER RESET button–
to 0:00:00. (only on the remote control)
EXIT button– Press to exit the menu on the TV
screen. (only on the remote control)
20.
SEARCH MODE button–
Search or an Index Search. (only on the remote control)
21. Power cord– Connect to a standard AC outlet
(110-220V, 50/60Hz).
22.
AUDIO OUT jack– Connect to the audio input jack
of your audio equipment or another VCR.
23. Connect to the audio output jack of
AUDIO IN jack–
your audio equipment or another VCR.
24. Connect to an antenna, Cable
ANT. IN terminal–
system or Satellite system.
25. Connect to the video input jack
VIDEO OUT jack–
of your video camera or another VCR.
26. Connect to the video output jack of
VIDEO IN jack–
your video camera or another VCR.
27. CH3/CH4 selector switch–
output channel (3 or 4) for VCR playback.
28.
ANT. OUT terminal–
terminal on your TV.

INSTALLING THE BATTERIES

1) Open the battery compartment cover by pressing the
cover on the remote unit in the direction of the arrow.
2) Insert 2 "AA" penlight batteries into the battery com-
partment in the direction indicated by the polarity
(+/-) markings.
3) Replace the cover.
Install 2 X AA battery
- 16 -
Press to reset counter
Press to perform a Time
Use to select a video
Connects to the antenna input
1B14
EN