Publicidad
Idiomas disponibles
Idiomas disponibles
PACKAGE CONTENTS
• Aeromesh® Rapid-Dry Bath Belt
• Optional: Frame Clamps (Art. No. HW310),
Band Clamps (Art. No. HW320), Knob (Art. No.
FA812-BP)
A
MOUNTING SUGGESTIONS
At Chest, At Knees (Preferred)
A
Taking into account the user's needs, find a
suitable mounting location on the wheelchair
that allows the belt to be mounted at one of the
preferred positions shown.
INSTALLATION
Direct Screw Mounting
If mounting directly to chair frame or solid seats/backs,
use 6mm (1/4-20) Flat head or Button head screws.
Mounting screws must have a minimum pullout
strength of 90kg (200lbs). Not included in package.
POSITIONING
Seat user in shower/commode chair and establish correct
posture. Determine desired position for the belt. When
choosing position, consider interference with other devices.
To reduce the risk of strangulation and trunk instability, the
belt should be neither too high nor too low.
B
Across Thighs
B
(Optional)
With Frame Clamps or Band Clamps
Attach clamps to shower/commode chair in desired
locations and tighten in place. Insert second screw
through grommet on belt and into the clamp.
Tighten securely.
ADJUSTMENT
With the user correctly seated, check the fit of the belt – it should be snug
so the user is secure. Small adjustments in fit are done using the D-ring
tightening strap. Large adjustments in fit are done using the mounting
grommets.
SAFETY CHECK
When properly positioned in chair, have user lean forward and side-to-side
to check fit. Check for:
1. Normal operation of buckle and adjustment straps.
2. Comfort - Look for areas of irritation.
3. Position - If too high or too low, adjust mounting points.
4. Interference with other devices – Relocate mounting points as necessary.
5. Move chair through full range of motion, including tilt, folding, and
rolling. Check for any interference.
C
Tilting Chairs
C
Belt must be mounted to the upper frame,
above the pivot point. Mounting the belt
below the pivot point can cause interfer-
ence or affect belt tension.
4mm (5/32")
en
Optional
Art No.
FA812-BP
Publicidad
