Craftsman 900.11647 Guia De Inicio Rapido página 3

479218-00 01 11647 Searsnewone
eye protection. Dust mask, non-skid
safety shoes, hard hat, or hearing
protection must be used for appropriate
conditions.
TOOL USE AND CARE
• Use clamps or other practical way to
secure and support the workpiece to a
stable platform. Holding the work by
hand or against your body is unstable
and may lead to loss of control.
• Do not force tool. Use the correct tool
for your application. The correct tool
will do the job better and safer at the rate
for which it is designed.
• Do not use tool if switch does not turn
it on or off. Any tool that cannot be
controlled with the switch is dangerous
and must be repaired.
• Disconnect the plug from the power
source before making any
adjustments, changing accessories,
or storing the tool. Such preventative
safety measures reduce the risk of
starting the tool accidentally.
• Store idle tools out of reach of
children and other untrained persons.
Tools are dangerous in the hands of
untrained users.
• Maintain tools with care. Keep cutting
tools sharp and clean. Properly
maintained tools, with sharp cutting
edges are less likely to bind and are
easier to control.
• Check for misalignment or binding of
moving parts, breakage of parts, and
any other condition that may affect the
tools operation. If damaged, have the
tool serviced before using. Many
accidents are caused by poorly
maintained tools.
• Use only accessories that are
recommended by the manufacturer for
your model. Accessories that may be
suitable for one tool, may become
hazardous when used on another tool.
SERVICE
• Tool service must be performed only
by qualified repair personnel. Service
or maintenance performed by unqualified
personnel could result in a risk of injury.
• When servicing a tool, use only
identical replacement parts. Follow
instructions in the Maintenance
section of this manual. Use of
unauthorized parts or failure to follow
Maintenance Instructions may create a
risk of electric shock or injury.
The label on your tool may include the
following symbols.
V..............volts
A..............amperes
All manuals and user guides at all-guides.com
4/12/07 8:15 AM Page 3
Hz............hertz
W ............watts
min ..........minutes
............alternating current
........direct current
no ............no load speed
............Class II Construction
.../min......revolutions or reciprocation
................per minute
............earthing terminal
............safety alert symbol
SAFETY WARNINGS AND
INSTRUCTIONS: SANDERS
• ALWAYS WEAR EYE PROTECTION.
• Clean your tool out periodically.
CAUTION: Wear appropriate hearing
protection during use. Under some
conditions and duration of use, noise from
this product may contribute to hearing
loss.
WARNING: Some dust created by
power sanding, sawing, grinding,
drilling, and other construction
activities contains chemicals known to
cause cancer, birth defects or other
reproductive harm. Some examples of
these chemicals are:
• lead from lead-based paints,
• crystalline silica from bricks and cement
and other masonry products, and
• arsenic and chromium from
chemically-treated lumber. (CCA)
Your risk from these exposures varies,
depending on how often you do this type
of work. To reduce your exposure to these
chemicals:work in a well ventilated area,
and work with approved safety equipment,
such as those dust masks that are
specially designed to filter out microscopic
particles.
• Avoid prolonged contact with dust
from power sanding, sawing, grinding,
drilling, and other construction
activities. Wear protective clothing
and wash exposed areas with soap
and water. Allowing dust to get into your
mouth, eyes, or lay on the skin may
promote absorption of harmful chemicals.
WARNING: Use of this tool can
generate and/or disburse dust, which
may cause serious and permanent
respiratory or other injury. Always use
NIOSH/OSHA approved respiratory
3