AquaSource 67356-6001 Manual Del Usuario página 4

ASSEMBLY INSTRUCTIONS
2. Install the faucet:
a. Remove the preassembled mounting brackets
(C) and mounting nuts (D) from the faucet (A)
and place the base plate (B) and the faucet (A) in
position on the sink.
Note: If the sink surface is uneven, use silicone
sealant (not included) to create a watertight seal.
b. From under the sink, slide the mounting brackets
(C) and mounting nuts (D) onto the threaded bolts
on the faucet (A).
c. Tighten the mounting nuts (D).
Note: Tighten the mounting nuts with a wrench until
snug. Do not overtighten.
3. Connect a 1/2 in. IPS faucet connector or coupling nuts
(not included) with 3/8 in. O.D. ball-nose risers (not
included) to the water supplies underneath the sink
using wrenches (not included).
Note: Refer to the local plumbing codes for permissible
types of water supply connectors.
4. Before tightening the faucet connector to the water
supply, apply a second wrench to the supply tube
This will prevent the supply tube from moving or
twisting when tightening the faucet connector. Do not
overtighten.
2
A
C
D
3
4
4
B
Lowes.com