Setup And Installation; Setup And Use - Biamp Vocia CI-1 Manual Del Operacion

CI-1 Setup and Installation

Setup and Use

The CI-1 interfaces directly to LSI-16(e) devices and external equipment.
NOTE: To operate correctly, the CI- 1 requires an accompanying LSI16(e) plus connections to external
components and devices as described in this manual.
The CI-1 should be mounted in close proximity to the accompanying LSI16(e).
For EN 5416 compliance, refer to the Vocia VACIE Reference Guide which details mandatory installation
requirements.
Incorrect configuration, removal, or non-installation of some system elements may result in the LSI-16(e)
or CI-1 reporting a fault or alarm condition. This is normal operation. For correct, fault-free operation,
inputs and outputs must be connected to the LSI-16(e) and CI-1 or external equipment as detailed in this
manual.
Installation
Install the unit away from heat sources, such as vents and radiators, and in rooms with adequate
ventilation. Ensure that air can circulate freely behind, beside, and above the unit. Do not exceed the
maximum ambient operating temperature of 32° - 108° F (0° - 42°C). Be aware of conditions in an
enclosed rack that may cause the temperature to exceed ambient room conditions.
The unit requires one 1.75 inch (44.45 mm) high and 19-inch-wide rack space with 10 inch (254 mm)
depth. Mounting the unit using four screws with washers will prevent marring of the front panel. PVC or
nylon washers are appropriate.