Using The Electric Bain Marie - KBS NB74ED Manual De Instrucciones

use. Any other use is considered to be im-
proper.
• Do not allow the appliance to operate emp-
ty for prolonged periods. Only pre-heat the
oven just before use.
• Do not leave the appliance unattended
while in operation.
• In the event of an appliance fault or mal-
function, shut the gas shut-off valve and/or
switch the appliance off at the main switch
installed upline.
• Clean the appliance following the instruc-
tions given in Chapter " INSTRUCTIONS
FOR CLEANING".
• Do not store flammable materials in close
proximity to the appliance. FIRE HAZARD.
• Do not obstruct any air vents or drains pre-
sent on the appliance.
• Do not tamper with appliance components.
• The use of personal safety equipment is
recommended - risk of very hot food being
scattered.
• During appliance operation, the floor sur-
rounding the appliance may become slip-
pery: exercise caution and take all suitable
measures to prevent falls.
• Take care when handling accessories (e.g.
pans) and movable parts of the appliance
to use the correct posture.
• Appliances of this type are intended for
use in commercial applications such as,
for example, the kitchens of restaurants,
canteens, hospitals and businesses such
as bakers, butchers etc., but they are not
intended for the continuous mass produc-
tion of food.

USING THE ELECTRIC BAIN MARIE

REMINDERS FOR USE
• The appliance is designed for indirect co-
oking of foods in cooking receptacles and
for keeping food warm in a bain marie.
• Do not activate the heating system when
there is no water in the well.
• While the appliance is on, the water level
must be maintained level with or above
8
the minimum level indicated on the wall of
the well.
• The appliance is equipped with a manual
reset safety thermostat which interrupts
heating when the operating temperature
exceeds the maximum permitted value.
• At the end of each day, clean the well tho-
roughly in order to prevent the formation of
corrosive deposits.
FILLING AND EMPTYING THE WELL
Filling
• Insert the overflow pipe in the drain hole
of the well.
• Fill the well until the water is level with the
maximum level indicated on the wall of the
well. Do not use the appliance with the
water level above the maximum indicated
level.
Fillingwithbutton
• Insert the overflow pipe in the drain hole
of the well.
• The water will come out from distributor.
• Fill the well until the water is level with the
maximum level indicated on the wall of the
well. Do not use the appliance with the
water level above the maximum indicated
level.
Emptying
Remove the overflow pipe from the drain
hole of the well.
SWITCHING ON AND OFF
The control knob has the following posi-
tions:
0 Off
1 On
The thermostat control knob has the fol-
lowing positions:
Off
30 Minimum water temperature
90 Maximum water temperature