König Electronic SEC-DUMMYCAM80 Manual De Uso página 2

Tabla de contenido

Publicidad

Security dummy camera
Introduction:
CCTV dummy camera in outdoor housing with (fake) IR LED. Professional design for the impression of
security. With built-in flashing LED. Adjustable mounting bracket included.
Placing the batteries:
Open the battery compartment at the back of the camera with a screwdriver. Place 2x AA 1.5V batteries
in the battery compartment, ensuring that they conform to the correct polarity marking inside the battery
compartment. After placing the batteries, close the battery compartment.
Adjusting the angle of the camera/bracket:
The camera/bracket can be adjusted in two ways.
1) Pull back the bracket while holding the camera in one hand. Turn the angle of the camera/bracket.
2) Loosen the screw in the bracket and adjust the angle. Do not forget to tighten the screw after the
angle is adjusted.
Specifications:
• Depth:
27 cm
• Height:
14.5 cm
• Diameter camera:
9.2 cm
• Battery:
2x 1.5V AA (not included)
• Housing:
plastic
• IP protection:
IP65
Maintenance:
Clean only with a dry cloth. Do not use cleaning solvents or abrasives.
Warranty:
No guarantee or liability can be accepted for any changes and modifications of the product or damage
caused due to incorrect use of this product.
ENGLISH
2

Publicidad

Tabla de contenido
loading

Tabla de contenido