Installation Preparation - Commercial Electric 55704141 Manual De Instalación

InstallatIon PreParatIon

4. Plug one end of the power cord/linking cable (DD) into the
receptacle at the end of the shop light (A). Insert the other
end of the power cord/linking cable (DD) into the electrical
plug adapter (AA), and then plug the electrical plug adapter
(AA) into an electrical outlet.
EE
A
Pull Chain
6. Attach the power cord (DD) to the chain (EE) with the cable tie (FF) provided.Pull the chain down to turn the light on and off.
warnIng:
RISK OF ELECTRIC SHOCK. Disconnect power to the shop light before linking additional shop lights.
lInkIng multIPle sHoP lIgHts
Multiple light fixtures can be connected, up to a maximum of five 4 ft. shop lights or 300 total watts. Only the first light fixture
needs to be plugged into an electrical outlet.
□ Connect each additional fixture using either the linking cable (DD) or end-to-end connector (BB). when using the linking
cable (DD) , the maximum distance between two light fixtures is 5 ft.
note:
For best results, fully insert the linking cable or end-to-end connector into the receptacle in the end of the shop light.
warnIng:
RISK OF ELECTRIC SHOCK. If the receptacle on the end of the shop light is not used to link to another fixture, the receptacle needs to be closed
by the end cap (CC). Do not touch live parts inside the receptacle.
DD
EE
A
Pull Chain
BB
DD
5. Plug the end cap(CC) into the other receptacle at the end
of the shop light.
CC
AA
FF
EE
AA
DD
A
EE
A