Stanley FATMAX SFMCMS2653 Traducido De Las Instrucciones Originales página 17

TROUBLESHOOTING
If your appliance seems not to operate properly, follow the
instructions below. If this does not solve the problem, please
contact your local STANLEY FATMAX repair agent.

WARNING: Before proceeding, release the bail bar to turn
mower off and wait for the blade to stop.
Problem Possible solution
Mower doesn't run Check to make sure mower battery is properly
when bail handle installed and that the button on switch box is
is activated being completely depressed before pulling the
bail handle.
Release bail handle to turn mower off. Remove
safety key and battery pack, turn mower over and
check that blade is free to turn.
Check that the battery cavity is free of debris and is
connected properly.
Has battery been fully charged? Press state of
charge button.
Motor stops Release bail handle to turn mower off. Remove
while mowing safety key and battery pack Turn mower over and
check that blade is free to turn.
Raise cutting height of wheels to highest position
and start mower.
Check that the battery cavity is free of debris and is
connected properly
Has battery been fully charged? Press state of
charge button
Avoid overloading the mower. Slow down the
cutting pace, or raise the cut height.
Mower runs but Release bail handle to turn mower off. Uninstall
cutting performance power source. Turn mower over and check:
is unsatisfactory
• Blade for sharpness - Keep blade sharp.
• Deck and discharge chute for clogging.
Wheel height adjustment may be set too low for
grass condition. Raise cutting height.
Mower is too hard Release bail handle to turn mower off. Uninstall
to push power source. Raise cutting height to reduce deck
drag on grass. Check each wheel for free rotation.
Problem Possible solution
Mower is abnormally Release bail handle to turn mower off. Uninstall
noisy and vibrates power source. Turn mower on side and check blade
to ensure it has not been bent or damaged. If blade
is damaged, replace with a STANLEY FATMAX
replacement blade. If the underside of the deck is
damaged, return mower to a STANLEY FATMAX
Authorised service centre.
If there is no visible damage to the blade and the
mower still vibrates:
• Release bail handle to turn mower off.
• Unplug mower.
• Disassemble entire blade assembly as
described in the Removing and installing
blade section.
• Remove any debris and clean each piece.
• Replace each piece as described in the
Removing and installing blade section.
If mower still vibrates, return the mower to an
authorised STANLEY FATMAX service center.
Battery charger LEDs Check plug connection.
not on
Replace charger.
Mower not picking up Chute clogged. Release bail handle to turn
clippings with bag mower off. Uninstall power source. Clear chute of
grass clippings.
Raise cutting height of wheels to shorten length
of the cut.
Bag full. Empty bag more often.
English
15