STACK-ON PS-5-B-12 Manual De Instrucciones página 3

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

RECORDING FINGERPRINTS
● When you first receive your safe there
are no recorded fingerprints.
● You can record up to 32 different
fingerprints for opening the safe.
1.
Press the Red Reset button on the
inside of the door. Two "beeps" will
sound and a red light will glow around
the fingerprint scanner.
2.
Place your finger on the fingerprint
scanner. Two "beeps" will sound.
● The fingerprint has been
successfully recorded if there is
one extra "beep" and the green
light flashes.
● The fingerprint has not been
recorded if there are two extra
"beeps" and both lights flash.
Try recording again from step 1.
TIPS FOR RECORDING FINGERPRINTS
● In order to improve the rate of fingerprint
identification please follow these suggestions:
Locate the safe at a height that allows
easy access to the fingerprint scanner.
Record several of your fingerprints in
case you sustain a cut or an injury to a
finger you have scanned.
When scanning, use moderate finger
pressure (not too hard or light) on the
scanner. Center your finger on the
scanner. Use a similar pressure and
finger location on the scanner when
opening the safe.
For smaller hands we recommend using
the thumb and middle finger.
Do not use the fingerprint scanner under
bright lights.
If your hands are dry, breathe on your
finger tips to improve the scan.
If your hands have oil, lotion or are dirty
the fingerprints may not scan correctly.
Correct
Incorrect
3
21
40274-1306

Publicidad

Tabla de contenido
loading

Tabla de contenido