Drainage Connection; Mechanical Rinse Aid Dispenser; Detergent Dispenser - ASBER T-OEM-350 Instrucciones De Instalación, Uso Y Mantenimiento

EN

4.5 Drainage connection

The water draining from the machine must flow freely and therefore the drainage pipe should be lower
than the drainage outlet Fig. 4. If the drainage pipe is not lower, a drainage pump will be required. This
must not be mounted at a height of more than 680 mm Fig. 5. In this case, the pump may be requested
at the time of purchase or subsequently.
Fig. 4. Drainage installation.
Fig. 5. Installation of drainage at a height using drainage pump.
The drainage pump must only be installed by personnel authorised by the
manufacturer, and the manufacturer does not accept liability in the event of
incorrect installation.

4.6 Mechanical rinse aid dispenser

Installation: Take the tube located in the back or your machine marked "Rinse Aid" and place
inside
rinse container.
Tubes are transparent to provide you visible mean that chemicals are being dispensed.
Operation: This dispenser absorbs the rinse aid when it detects a loss in pressure during rinsing. That
is, when the filling solenoid valve closes, a vacuum is created that makes the rinse aid dispenser
absorb the fluid to which it is connected.
Adjustment: The dispenser should be adjusted when the machine is installed to ensure that the wash
is optimised from the start. The setting should be adjusted according to the type of rinse aid and the
water hardness.
4.7 Detergent dispenser (Optional
Use ONLY Commercial Grade, High Temperature, Low Suds Liquid Detergent. Manufacturer
doesn't recommend any specific brand name of chemicals. Contact your local chemical distributor for
questions concerning your chemical needs.
Installation: the detergent dispenser input is in the wash tank front part, above the maximum water
level.
Take the tube located in the back or your machine marked "Detergent" and place inside detergent
container.
This ensures that the correct measure of detergent is supplied to the machine. Fig. 1
Installation: the detergent dispenser input must be in the tub of the machine, above the maximum
water level. Please see the electrical circuit diagram for details of the electrical connection. The tub
has an opening for the installation of the dispenser, marked with an adhesive label as "DETERGENT
CONNEXION".
Operation: the detergent dispenser is activated when the machine is taking water, whether it is in
rinse cycle or whether it is filling. Settings: the measure of detergent used should be adjusted when
the component is installed t ensure that the wash is optimised from the start.
It is recommended that the detergent and the dispenser setting are defined by a
technician specialised in the use of chemical products to ensure a more efficient wash.
4 31mm in diameter and must be installed in accordance with AS/ NZ3500.2 (drainage) by means of coupled
connection to a DN40 or larger pipe
4
Detergent
Filter
45
Time pause regulation
Conduit to wash
tank