Axis P7216 Manual Del Usuario página 15

Note
The auxiliary connector should only be connected during maintenance work and should not
be connected to the same network as the SFP/NET connectors.
Network Redundancy
The video encoder have built-in network redundancy functionality. The network redundancy
functionality works automatically and requires that both the SFP module and the RJ45 connector
(NET) are connected.
Note
The auxiliary RJ45 (AUX) connector does not provide redundancy functionality.
Access the Product
Use the tools provided on the Installation and Management Software CD to assign an IP address,
set the password and access the video stream. This information is also available from the support
pages on www.axis.com/techsup/
Reset to Factory Default Settings
Important
Reset to factory default should be used with caution. A reset to factory default will reset
all settings, including the IP address, to the factory default values.
Note
The installation and management software tools are available on the CD supplied with the
product and from the support pages on www.axis.com/techsup
To reset the product to the factory default settings:
Note
To reset a single channel to the original factory default settings, use the button provided in
that unit's web interface.
It is also possible to reset parameters to factory default via the web interface. Go to Setup
> System Options > Maintenance.
Further Information
The User Manual is available at www.axis.com
AXIS P7216 Video Encoder
15