Duronic EPS Manual De Instrucciones página 9

Plug the cable into a mains power socket.
The screen is controlled by the wired-in control
on the side of the screen. It has three buttons:
UP / STOP / DOWN.
The screen can also be controlled by a wireless
remote (sold separately), which has the same
buttons: UP / STOP / DOWN. The remote control
frequency is: 433 MHz.
When not in use, keep your screen rolled up to keep it dust-free. If the screen
or casing gather dust, simply clean with a dry cloth or duster.
The screen is made of PVC. If the screen has a mark or stain that needs to
be removed, use a wet cloth with a mild soap to gently clean the screen. Use
minimal pressure to prevent damaging the fabric.
Do not use any abrasive chemicals or cleaning agents on any part of the
screen or casing.
Problem
The screen does not
go up or down
Screen does not
extend to the correct
length
Screen does not
completely retract
Operating Instructions
Cleaning
Troubleshooting
Solution
Check that the power cable is connected properly
and that it is switched on at the mains power
socket. If the screen still does not move up or
down, contact Duronic directly for further advice.
If the screen does not extend to the correct length,
use the hex tool to turn and adjust the red or grey
(A) hex screw inside the projector casing. (See
'Setting Up the Screen')
If the screen does not retract fully into the projector
casing, use the hex tool to turn and adjust the white
or yellow (B) hex screw inside the projector casing.
9
Up
Stop
Down
Up
Stop
Down