Horizon Global 76434 Instrucciones De Instalación página 5

2c.) Located at the inside of the rear wheel well are screws that will be
2b.) Located at the outer bottom edge of rear bumper fascia near the wheel
removed. Using a T15 star driver remove (3) screws. Both sides.
well, remove (1) screw. Both sides.
2d.) Located below the taillight is a screw that will need to be removed. Using
2e.) Using a plastic trim tool, starting at the outer ends near wheel well,
a T20 star driver, remove (1) screw. Both sides.
partially remove the fascia by gently pulling rearward while releasing the clips
holding the lower portion of the wheel well trim. Do not remove top portion of
wheel well trim otherwise will not reinstall properly.
©2021 Horizon Global™ Corp - Printed in Mexico Sheet 5 of 27 76434NP 1-11-21 Rev. A