Horizon Global 76434 Instrucciones De Instalación página 6

2f.) Using a M7 hex socket, pulling back the wheel well trim, remove (2) screws
from both sides.
3. Remove bumper beam – Remove the caulking around the bumper beam mounting surface. Using a 15mm socket with extension, remove (6) M10 flange hex nuts.
Set bumper beam aside. Keep M10 hex flange nuts for hitch installation. See Figure 1.
Bumper beam
Existing M10 Hex Flange Nut
(6) Places
©2021 Horizon Global™ Corp - Printed in Mexico
End panel
Figure 1
2g.) If equipped, disconnect all wiring harnesses from fascia and carefully set
fascia aside.
Existing M10-1.25 Stud
(6) Places
Silicone sealant areas
Sheet 6 of 27 76434NP 1-11-21 Rev. A