ATTACHING THE AIR PURIFYING FILTERS
CAUTION
Cleaning and maintenance must be carried out when À lter lamp lights. Before cleaning, stop operation
and switch off the power supply.
1
Open the front panel
●
Pull up the front panel by holding it at both sides with
both hands.
2
Remove the Pre-À lter
●
Push upward to release the claws and pull out the
Pre-À lter.
3
Attaching the air purifying À lters
●
Attach the air purifying À lters to the frame by gently
compress its both sides and release after insertion
into Pre-À lter frame.
CAUTION
Do not bend the air purifying À lter as it
may cause damage to the structure.
Please do not smell direct from source
of À lter.
4
Attach the Pre-À lters
●
Attach the Pre-À lters by ensuring that the surface writ-
ten "FRONT" is facing front.
●
After attaching the Pre-À lters, push the front panel at
three arrow portions as shown in À gure and close it.
NOTE
●
In case of removing the air purifying À lters, please follow the above procedures.
●
The cooling capacity is slightly weakened and the cooling speed becomes slower when the air purifying
À lters are used. So, set the fan speed to "HIGH" when using it in this condition.
●
Do not operate the air conditioner without Pre-À lter. Dust may enter the air conditioner and fault may
occur.
Claws
(4 places)
– 9 –