Replacing The Batteries; Getting Started - Thermo Fisher Scientific Elite PCTS Instrucciones De Operación

This instruction manual is applicable for Elite PCTS Tester.

Replacing the Batteries

The Elite PCTS tester uses four AAA 1.5 V batteries.
1. To remove the battery cover, See Figure 1. Clear the front catch and then the back
catch, before sliding the cover off.
2. To remove the battery plate, push the center tab towards the front of the tester as
show in Figure 2. Once unlocked, remove the plate to access the batteries.
3. Invert the tester upside down to remove the batteries. Each side uses two
AAA batteries. Orient each battery with positive terminal facing downward.
4. To lock the battery plate, align the small taps into the guide ribs
To Release the battery plate,
on the housing and then press down. See Figure 4.
Push away this tap.
Figure 2: Push to unlock
Figure 5: Battery plate unlock position

Getting Started

To Insert battery plate,
align the small taps into
the guide ribs on the
The Elite PCTS tester has been factory calibrated and usually works well out of the box. However, after extended housing
periods of non-use, it is best to remove the sensor cap and soak the sensor in warm tap water for 10 minutes or so.
Prior to taking the measurements, periodic calibration with certified standards is recommended for best accuracy.
Measurement Parameter Setting
1. Press to power the tester on.
2. Press to enter setup window. Press
3. Scroll down by pressing
4. The display shows the selected measure with a
Key Info
Scroll
Accept
EXIT
2
All manuals and user guides at all-guides.com
Battery Plate Unlock position
To Insert battery plate,
align the small taps into
the guide ribs on the
To Insert battery plate,
housing
align the small taps into
the guide ribs on the
housing
Figure 3: Align tabs
Battery Plate Unlock position
Battery Plate Unlock position
To Insert battery plate,
align the small taps into To lock the battery plate,
To lock the battery plate,
the guide ribs on the press down and slide in
press down and slide in
housing
to select Measure. The display shows pH, Cond, TDS and Salinity.
to toggle between pH, Cond, TDS and Salinity. Press
Measure
Settings
Temp Set
Reset
Battery Plate locking position
Battery Plate Unlock position Battery Plate locking position
To lock the battery plate,
press down and slide in
To lock the battery plate,
press down and slide in
Figure 4: Push down to lock
Figure 6: Battery plate lock position
Battery Plate locking position
Battery Plate locking position
To Release the battery plate,
Push away this tap.
.
pH
Cond
TDS
Salinity
To Release the battery plate,
Figure 1: Removing Battery
Push away this tap.
To Release the battery plate,
cover
Push away this tap.
To Release the battery plate,
Push away this tap.
to select pH.
pH
Elite PCTS Tester Operating Instructions