Blumfeldt Fiamme Tamburo Manual Del Usuario página 23

OPERATION
Notes on the Fuel
Note: Ethanol is not included and must be purchased separately from a DIY
store or fuel retailer.
• The fuel used in the fireplace should be stored in a shady and safe place.
• Use 95 % bio-ethanol refined from plants.
Note: Use only bio-ethanol as fuel.
Ignite Fire
(1) Slowly pour the fuel into a clean, cool burner or burner pot. Use the funnel
for filling. Fill the burner to a maximum of 2/3. Do not fill too much fuel
and do not allow the fuel to come into contact with objects other than the
inside of the burner. Replace the bottle cap and place the bottle far away
before lighting. Store the fuel bottle in a dry, cool room. Do not store it in
places where it may be exposed to direct sunlight and warm up.
Note: Spilled fuel may stain floors or furniture.
(2) If fuel has been spilled, clean and dry the affected areas before ignition.
(3) Do not add fuel while the fire is burning or the burner is still hot. Wait 10-
20 minutes for the burner to cool down before refilling with fuel.
(4) Use a fireplace lighter (not supplied) to ignite the fuel.
(5) Make sure that all persons present are 20-30 cm away from the fireplace
when you ignite it.
Note: The flame begins to flicker slowly. The flame may initially be low and
almost invisible, so allow the flame 15 minutes to reach the optimum level.
(6) We recommend that you leave the fireplace burning until all the fuel has
been burned.
EN
23