EGAmaster ROSCAMATIC 80-3 Manual De Instrucciones página 13

Lubricate the gear and rack that make the carriage drive.
Be carefull that bar and profiling board teeth are in good condition, replace them when they will
not lock and the profiling will not be produced.
M) HAMMER CHUCK
Keep the chuck-jaws clean so that they swing and they are not blocked.
Replace the chuck-jaws when their theeth is damaged or worn out and the don't make correctly
the pipe turning retention.
N) MOTOR
Take into account that this motor has a condenser that must be kept clean and dry, replace it
when necessary. This is placed beside the motor.
G
IMPORTANT!
The maker will not take responsibility for damage or malfunction as a result of the Testing Pump
being incorrectly used or, applied for a purpose for which it was not intended.
For ordering spare parts, please refer to the Spare Parts Drawing and note the needed number.
The maker guarantees to the machine owner 12 months against any manifacture defect.
This guaranteee do not cover the parts wich are consumables.
Note: to apply the guarantee its necesary to send the "GUARANTEE CERTIFICATE" duly filled
within one week after purchased the machine to the maker.
G
NOTES
GUARANTEE
J
13