SPACER ATTACHMENT
For delicate fabrics or long-hair fabrics, put the spacer
attachment over the cover (2) – Fig. 1.
The distance between the attachment and the cover can be
adjusted – Fig. 2.
GUIDELINES
1. Do not shave clothes in case clothes are at a body. It may
cause wounds on a body.
2. When shaving clothes pay special attention to:
- areas around buttons and zips
- protruding parts
- connections – sews
- object glued to clothes
- delicate parts
3. Before use try the unit on a hidden part of a cloth.
4. Move the unit acc. to a pattern on a cloth.
5. If required move the unit alongside – vertically and
horizontally
6. In case of 'flat 'materials lay two layers of a cloth and shave
them on an iron board.
7. Do not switch the unit on when it is unnecessary, it may
result in reduced life of the shield and the blade.
MAINTENANCE AND CLEANING
When the container is approx. 80% full clean it and internal blades as well.
Before cleaning unplug the unit and switch it off.
- do not merge the unit in water
- to not use abrasive or other damaging cleaning agents
- clean the casing with a wet cloth
- remove the casing (2) twisting it counterclockwise
- remove the blade (3)
- using a little brush (10) clean the casing, blade and the drive mechanism
- empty the container (9)
Be careful then removing and cleaning the blade (3) since it is sharp
Be gentle when cleaning the metallic foil of the casing (2). Do not press it.
ENVIRONMENT PROTECTION
- the unit is made of materials which may be reused or re-cycled
- it must be provided to a relevant point specializing in collecting and recycling of electric and electronic
appliances
•
EN
9