Technical Data; Safety Instructions; Air Source - BGS technic 3215 Manual De Instrucciones

TECHNICAL DATA

Aluminium Diecast Body
Nozzle length:
Air inlet:
Recommended Hose
Averange
Air Consumption:
Max Pressure:
Noise:
Vibration:
Weight:
CAUTION
Read and understand all rights and information in this manual.
Failure to comply with unconscious rights and information may include control and oversight.
Keep the operating instructions in a certain and controlled place for future reference.

SAFETY INSTRUCTIONS

•
Only operate with compressed air systems that have the correct air pressure and sufficient
air volume (L / min) for this tool.
•
Ensure that the tool is in the OFF position when it is connected to the compressed air
system.
•
Always wear approved safety glasses when using compressed air tools. Wear a suitable
respirator when dust is whirled up.
•
Only use accessories suitable for compressed air. Risk of injury.
•
Disconnect the tool from the compressed air supply before installing accessories or
performing maintenance or before the device is not in use.
•
Always use the tool with common sense. Do not wear loose clothing or jewelry that can be
caught by moving parts as it can cause injury.
•
Only operate the tool at a safe distance from yourself and others.
•
Observe the manufacturer's instructions for the compressed air system when installing
regulators, filters and other accessories.
•
Keep children and other unauthorized persons away from the work area.
•
Do not let children play with the tool or its packaging.

AIR SOURCE

Clean and dry air and a correct air pressure is recommended as air supply for this air tool.
Maximum of 90 PSI at the air tool is recommended for most air tools of this class. Check
specifications section for recommended pressure. (Depending on length of air hose and other
circumstances, air pressure at compressor may need to be increased to 100 PSI to ensure 90 PSI at
the tool. Water in the air hose and compressor tank contributes to reduced performance and damage
of the air tool. Drain the air tank and filters before each use and as necessary to keep the air supply
dry. Hose length over 25" causes loss in line pressure. Increase hose ID or increase compressor
pressure to compensate the pressure
pressure is critical.
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Air Blow Gun
25 - 100 - 200 mm
1/4"
Ø: 3/8" (10 mm)
145 L/min
8 Bar
LpA = 90 dB(A)
LwA = 101 dB(A)
ahd = 2.5 m/s²
K = 1.5 m/s²
260g
loss. Use an in-line pressure regulator with gauge if air inlet
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
BGS 3215
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed