Transportation - V-TAC VT-2000 Manual De Instrucciones

1. Once the device has been positioned successfully maintaining the minimum distance placement of the device
(Min 50-100CMs).
2. Ensure power is switched OFF and connect the EU plug into the power outlet and switch the power ON.
3. Turn the thermostat knob fully in clockwise direction to the maximum setting.
4. Turn on the power by means of the thermostat knob on the side panel. When the power is on, the power
indicator will light up.
5. Then turn on the heating function by means of the function selector switch "I" on the side panel. For maxi-
mum heat output the selector switch should be turned to the most high-grade "II".
6. When the desired room temperature has been reached, the thermostat knob should be turned slowly
anti-clockwise until the thermostat is heard to click off and the lights on the switches are OFF.
7. After this the heater will keep the air temperature in the room at the set temperature by switching on and off
automatically.

TRANSPORTATION

Please ensure to transport the device properly, failure to do so may result in damaging the device.
Before transporting or moving or adjusting the device please ensure to follow the below steps.
1. Switch off the power and unplug the mains plug from the mains socket.
2. Ensure the device is cooled down properly.
3. Use the side gripping points for transporting it from one point to another.
12
ENGLISH