Overmax Multipic 2.4 Manual De Usuario página 15

1. Power supply
Connect one tip of the feeder cable to the projector (1) and then another
plug to power supply network port (2).
2. Switching on and off
To switch the projector on or off , press on/off key on the remote control or
projector (3).
3. Sharpness and screen angle adjustment
Place the projector in a way that the lens is perpendicular to the wall or
board on which the image is to be displayed. Once the device has been
switched on, the main menu will be displayed:
To increase sharpness of the image, turn the
sharpness knob (2) located behind the lens (1) so that
the image gets sharper.
If the image is not displayed perpendicularly, it will
be distorted.
Distorted image in the shape of the trapezoid (see
fi gure below) can be adjusted with the use of a knob (3).
EN