WAGNER FELIX Manual Del Usuario página 9

FELIX
INSTALLATION
Choose a site for installation with as much irradiation as possible. Do not place the
FELIX in the shade of trees, bushes or buildings, as this will greatly reduce the degree
of efficiency of the FELIX.
PERFORMANCE
The performance of your FELIX depends on the time of year. FELIX is ready for opera-
tion longer in summer than in winter.
How long FELIX shines at night depends on how long FELIX was exposed to direct
solar radiation during the day. For example, when the sky is overcast, less solar energy
is available to load the rechargeable battery. During the following night, the
duration of emission of light of FELIX is therefore shorter.
The duration of emission of light is strongly limited on winter days due to lower exposure
to solar radiation.
NOTE: Clean the solar module regularly with a damp towel to guarantee
optimum performance of the solar collectors. Do not use any
solvents for cleaning. Do not put any pressure on the solar module
during cleaning.
FAILURE CORRECTION
If FELIX should fail to function despite observance of all instructions, please
proceed as described in the following steps :
1) Turn the selector switch several times to the positions „OFF" and „ON".
2) It may occur that your FELIX is ready for operation but it is covered by
another source of light. In this case, relocate the solar station.
3) Ensure that your FELIX does not stand in the shade during the day.
4) Check the rechargeable battery for corrosion.
REMOVING / CHANGING THE RECHARGEABLE BATTERY (fig. 2 - 4)
ATTENTION: 1) When removing/replacing the rechargeable battery, the
selector switch must be in position „OFF"!
2) Use Original WAGNER rechargeable batteries only.
3) When inserting batteries, make sure the polarity is
correct (+/-).
Remove the cover of the rechargeable battery
●
Remove the rechargeable battery to re-load it and/or exchange it
●
Re-assembly is accordingly conducted in the reverse order.
All manuals and user guides at all-guides.com
GB
.
5