SCALESON S170 Manual De Instrucciones página 18

7. Display and fault messages
Display
1. Max. CAPACITY
not equal to the one
marked on the
overlay
2. Every function
invalid
3. Measurement units
missed
The weighing is not
accurate
18
Possible cause
CONFIG and USER parameters are not set
correctly
1. An object is trapped between the load
cell and the bottom of the scale
2. Load cell was hit hard
Remedy
Reset CONFIG and USER parameters
according to the user calibration.
1. Remove the object
2. Perform linearity calibration
3. Loosen the transport safety screws.
4. Place the load on the centre of the
weighing platform