Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Product Safety Information
Intended Use:
These Air Drills are designed for drilling, honing, reaming and hole sawing.
For Additional information refer to Air Drills Product Safety Information Manual Form
04580353.
Manuals can be downloaded from www.ingersollrandproducts.com.
Product Specifications
Free Speed
Models
44SMA,
44SMA-EU
Models
44SMA,
44SMA-EU
Installation and Lubrication
Size air supply line to ensure tool's maximum operating pressure (PMAX) at tool inlet. Drain
condensate from valve(s) at low point(s) of piping, air filter and compressor tank daily. Install a
properly sized Safety Air Fuse upstream of hose and use an anti-whip device across any hose
coupling without internal shut-off, to prevent hose whipping if a hose fails or coupling discon-
nects. See drawing 16573180 and table on page 2. Maintenance frequency is shown in a circular
arrow and defined as h=hours, d=days, and m=months of actual use. Items identified as:
1. Air filter
2. Regulator
3. Lubricator
4. Emergency shut-off valve
5. Hose diameter
6. Thread size
Parts and Maintenance
When the life of the tool has expired, it is recommended that the tool be disassembled,
degreased and parts be separated by material so that they can be recycled.
The original language of this manual is English.
Tool repair and maintenance should only be carried out by an authorized Service Center.
Refer all communications to the nearest Ingersoll Rand Office or Distributor.
16572240_ed2
Capacity in Steel
Drilling
rpm
in
155
2
Sound Level dB(A)
(ANSI S5.1-1971)
Pressure
98.0
Reaming
mm
in
mm
51
2
51
Power
(ISO3744)
111.0
7.
Coupling
8.
Safety Air Fuse
9.
Oil
10. Grease - during assembly
11. Grease - through fitting
EN
Morse Taper Socket
No.4
Vibration Level
(ISO28927)
m/s
2
< 2.5
EN-1
Publicidad
Tabla de contenido
