Troubleshooting - Silvercrest PMR SPMR 8000 B1 Manual Del Usuario

SilverCrest SPMR 8000 B1

Troubleshooting

You can solve most common problems yourself using the table below. If the problem persists after
checking the suggested solutions, contact our Service Hotline. You will find the phone number in the last
chapter, "Warranty and Service Information". Do not attempt to repair the product yourself.
Problem
Unable to power the PMR
on
No transmission
Short range,
communications interference
Reception interference
114 - English
Solution
 Press and hold the On/Off button [5] for at least three seconds.
 Charge the batteries of your PMR or insert new batteries.
 Set both radio transceivers to the same channel and if applicable the
same CTCSS or DCS code.
 Press and hold the PTT button [12] fully down while speaking.
 If there is interference in the transmission, switch to a different channel.
 The range depends on the environment. Steel constructions, concrete
buildings or use of the unit in a vehicle may reduce the range. If
possible, try moving to a place where you have free sight to the
receiving station.
 Move away from any electromagnetic sources (high-voltage power
lines, machines with electric motors, etc.).
 The sending and receiving units are placed too close together. Keep at
least 1.5 m between the two units.
 Try to see if the communication quality is better on a different channel.