Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
SPECIFIC SAFETY RULES FOR ROTARY TOOL
Safety Warnings Common for Grinding, Sanding,
Wire Brushing, Polishing or Abrasive Cutting-Off
Operations:
This power tool is intended to function as a grinder, sander,
wire brush, polisher or cut-off tool.
Read all safety warnings, instructions, illustrations and
specifications provided with this power tool. Failure to follow
all instructions listed below may result in electric shock, fire
and/or serious injury. Do not use accessories which are
not specifically designed and recommended by the tool
manufacturer. Just because the accessory can be attached
to your power tool, it does not assure safe operation. The
rated speed of the accessory must be at least equal to the
maximum speed marked on the power tool. Accessories
running faster than their RATED SPEED can break and
fly apart. The outside diameter and the thickness of your
accessory must be within the capacity rating of your power
tool. Incorrectly sized accessories cannot be adequately
guarded or controlled. The arbor size of wheels, flanges,
backing pads or any other accessory must properly fit the
spindle of the power tool. Accessories with arbor holes
that do not match the mounting hardware of the power tool
will run out of balance, vibrate excessively, and may cause
loss of control. Do not use a damaged accessory. Before
each use inspect the accessory such as abrasive wheels for
chips and cracks, backing pad for cracks, tear or excess
wear, wire brush for loose or cracked wires. If power tool
or accessory is dropped, inspect for damage, or install
an undamaged accessory. After inspecting and installing
an accessory, position yourself and bystanders away from
6
SPECIFIC WARNINGS AND SAFETY RULES
FOR ROTARY TOOL
the plane of the rotating accessory and run the power
tool at maximum no-load speed for one minute. Damaged
accessories will normally break apart during this test
time. Wear personal protective equipment. Depending on
application, use face shield, safety goggles or safety glasses.
As appropriate, wear dust mask, hearing protectors, gloves,
and workshop apron capable of stopping small abrasive or
workpiece fragments. The eye protection must be capable of
stopping flying debris generated by various operations. The
dust mask or respirator must be capable of filtrating particles
generated by your operation. Prolonged exposure to high
intensity noise may cause hearing loss. Keep bystanders
a safe distance away from work area. Anyone entering
the work area must wear personal protective equipment.
Fragments of workpiece or of a broken accessory may fly
away and cause injury beyond immediate area of operation.
Hold the power tool by insulated gripping surfaces only,
when performing an operation where the cutting accessory
may contact hidden wiring. Contact with a "live" wire will
also make exposed metal parts of the power tool "live" and
could give the operator an electric shock. Never lay the
power tool down until the accessory has come to a complete
stop. The spinning accessory may grab the surface and pull
the power tool out of your control.
• Do not run the power tool while carrying it at your side.
Accidental contact with the spinning accessory could
snag your clothing, pulling the accessory into your body.
• Regularly clean the power tool's air vents. The motor's
fan will draw the dust inside the housing and excessive
accumulation of powdered metal may cause electrical
hazards.
Publicidad
Tabla de contenido
