GYS Kit NUM MIG-1 Manual De Instrucciones página 6

INSTALLATION
WARNING
ELECTRIC SHOCKS CAN BE FATAL
Only experienced personnel authorised by the manufacturer may carry out the installation. During installation, make sure
that the generator is disconnected from the mains.
Video for the kit's installation:
NUM MIG-1
https://www.youtube.com/playlist?list=PL7Y7wApgIJaSwDJ9f
NUM MIG-1
https://www.youtube.com/playlist?list=PL7Y7wApgIJaTDVIgFrVxc1ZOBzCnXfehe
Any access to internal areas beyond the areas described in this video guide is prohibited and voids the warranty and any other form of support.
Indeed, these manipulations may be damaging to the parts and/or the internal electronic components of the generator.
HARDWARE ERROR
If the following error appears on the display, the configuration order
of the wire feeders «Master» N°1 / «Slave» N°2 was not followed.
The configuration is visible in the video (see above).
ON ON ON
Master
1 2 1 2 1 2
6
KIT NUM MIG-1
NUM MIG-1 + NUM-1
3_4KyWe84UZrinBp
NUM MIG-1 + NUM-1
(NUM MIG-1 + NUM-1 + NUM-2)
ON
Slave
1 2
NUM MIG-1 + NUM-1 + NUM-2
https://www.youtube.com/playlist?list=PL7Y7wApgIJaSwDJ9f3_4KyWe
84UZrinBp
The reels are delivered in «Master» configu-
ration (N°1).
For use in double wire feeders, one of the two
wire feeders must be configured as a «Slave»
wire feeder (N°2). To configure it, follow the
instructions in the video:
HARDWARE Error
NODE : MMI 2
CODE : 0000
BAD BANK ID for MMI-5
EN