GYS Kit NUM MIG-1 Manual De Instrucciones página 7

SCREEN DISPLAY
(NUM MIG-1 + NUM 1 + NUM-2)
Wire Feeder N°1 = Master
SWO (SAFE WELDING OFF) FUNCTION
The «Safe Welding Off» function mainly prevents the current's or voltage's power source from starting. It acts directly on the power source. This
function is also used to safely shut down the power source in the event of an emergency stop. This prevents the power source from being abruptly
shut down if a problem occurs. It should be noted that a break in the power supply following the charging power source is dangerous and can damage
the equipment.
The «Safe Welding Off» function on the Num MIG-1 kit must not be turned if not managed by an external module. If this does hap-
pen, the power source will display an error (error code = «830B, FPGA I_EMERGENCY_STOP»).
Turning on the SWO function:
(Find switch's location on the electronic card, page 23).
WARRANTY
The warranty covers faulty workmanship for 2 years from the date of purchase (parts and labour).
The warranty does not cover:
• Transit damage.
• Normal wear of parts (eg. : cables, clamps, etc..).
• Damages due to misuse (power supply error, dropping of equipment, disassembling).
• Environment related failures (pollution, rust, dust).
In case of failure, return the unit to your distributor together with:
- The proof of purchase (receipt etc ...)
- A description of the fault reported.
KIT NUM MIG-1
Wire Feeder N°2 = Slave
ON
The functionalities of the «Slave» wire feeder are
limited.
OFF
(default)
EN
7