Using Bluetooth - Wren V3US Guía De Inicio

Using Bluetooth (cont.)
solid
blue
Figure 5
Problem connecting? Visit wrensound.com/support for additional help.
38
To clear the V3US's memory of all
paired devices, press and hold the
Setup button on the rear of your V3US
and, while holding the Setup button,
press the Power button on the control
panel. The Volume indicator will blink
amber two times to indicate that the
memory has been cleared. When
the V3US is powered on again, and
Bluetooth has been selected as the
source, it will be in pairing mode and
ready to pair with a Bluetooth device
(see "Pairing with your V3US" on
pages 35-36).
Note: Clearing the V3US's memory will
also clear any WiFi connection between
your V3US and your network. To reconnect,
follow the instructions for connecting your
device.
After you have cleared your V3US's
memory, you must delete the Wren speaker
from your source device's list of available
Bluetooth devices before you can pair it
with the V3US again. To delete a previously
paired Wren V3US from your source device's
memory, follow the directions provided by
the device's manufacturer.
Important note on volume control
when using Bluetooth
As with all Bluetooth pairings with audio devices, the volume control of your
Wren V3US functions as a "master" volume control. That means that, when you
are using Bluetooth, the volume control on the V3US governs how loud your
music can play. Once you have set the volume level on the V3US, the volume
control on your source device allows you to play music ranging from very low
to as high as your V3US "master" volume setting allows. For best results, we
suggest setting the master volume control on the V3US at or near maximum
volume. The best way to determine where to set the volume on the V3US is to
use the following steps:
• Set the volume control on the V3US at about half of maximum.
• Set the volume control on your source device at or just below maximum.
• Play music that you are familiar with.
• Raise the volume control on the V3US in small steps until it is as loud as you
think you will want it to play.
• Turn the volume down on your source device. You will find that it goes from
the peak loudness you established all the way down through medium to
soft to inaudible.
• You can now use your source device to play music from very low to as
loud you have set the V3US to play. This enables you to manage volume
remotely using your source device.
39