Initial Operation; Using Cleaning Agents; Cleaning/Maintenance/Storage; Waste Disposal And Environmental Protection - Parkside PWB 30 A1 Traducción Del Manual De Instrucciones Original

GB IE

Initial Operation

Connecting without adapter:
1. Connect the high-pressure scrubber
to the spray gun of your PARKSIDE
high-pressure cleaner by inserting and
screwing in (bayonet locking device)
the high-pressure connection on the gun
side (1).
Connecting with adapter:
1. Attach the adapter (5) to the high-pre-
ssure connection (1) and turn it through
90° until it locks into place (bayonet
locking device).
2. Connect the spray gun of the high pre-
ssure cleaner (bayonet locking device)
and screw the cap nut (4) of the adap-
ter (5) against the spray gun.
On all surfaces, test the brush (5)
initially on a location that is not
visible, in order to ensure compati-
bility.
Disconnecting:
Removal of the pressure scrubber is in the
reverse order.
1. Release the cap nut (4) on the adapter
(5).
2. Release the locking devices by pres-
sing and turning through 90° in the
opposite direction (bayonet locking
device).

Using cleaning agents

Use a neutral, biodegradable cleaning
agent. Always use the cleaning agent in
accordance with the manufacturer's instruc-
tions.
10
Cleaning/maintenance/
storage
Always remove the mains plug of
the high pressure cleaner before
working on the device. Otherwise,
there is a risk of electric shock.
• Clean the equipment with a damp
cloth.
• The equipment is maintenance free.
• Store the equipment in a frost-proof
room.
Waste disposal
and environmental
protection
Be environmentally friendly. Return the
tool, accessories and packaging to a re-
cycling centre when you have finished with
them.

Spare parts/Accessories

Spare parts and accessories can be
obtained at
www.grizzly-service.eu
If you do not have internet access, please
contact the Service Centre via telephone
(see "Service-Center", page 11). Please
have the order number mentioned below
ready.
9 Adapter ....................... 30300505