Wahoo Speedplay Aero Guia De Inicio Rapido página 4

CLEAT INSTALLATION
3. FIT THE CLEAT SURROUND AROUND THE BASE PLATE
Cleat Surrounds are labeled "L" or "R".
Note: COMP pedals do not ship with
Cleat Surrounds.
4. FIT THE PROTECTOR PLATE TO THE SPRING & HOUSING
Spring & Housings are labeled "LEFT" or "RIGHT".
Protector Plates are not labeled.
The Spring & Housing ships pre-assembled to the Protector Plate. If they have
separated, gently snap them together using the two small tabs as a guide.
5. SCREW THE ASSEMBLY TO THE BASE PLATE USING THE PROTECTOR PLATE SCREWS
Install the Protector Plate Screws using a "Double X Pattern" (shown below).
Loosely engage all four Protector Plate Screws (Steps: A thru D).
A.
Set the desired le -right position then tighten the Protector Plate Screws
(Steps: E thru H).
Recommended tightening torque: 2.5 Nm.
E.
continued
B.
F.
C.
G.
Right Shoe
Right Shoe
D.
H.
Right Shoe