Publicidad
ASSEMBLY INSTRUCTIONS
We suggest you assemble your fireplace on a carpeted surface or on a towel to avoid any scratches to your floor or fireplace.
Please disassemble Rods (Part D) from fireplace body (Part A) by removing the screws and rubber washers
(Parts E/F) before beginning assembly steps below.
Step 1
Put fireplace body (Part A) upside down and
insert support rods (part D) into each side,
across the inside of the body, so that the rods
line up with the pre-drilled set of holes on each
side the fireplace body.
Step 2
Turn fireplace body on its side with the narrow sides facing the
floor and ceiling and place first glass piece
(Part B) alongside the body so the holes in the glass line up with
the holes in the fireplace frame. It may help to have another
person assist in holding the glass steady when attaching.
Note: The fireplace is designed to be suspended between the glass
pieces 7 inches from the screws to the floor. Holes in the glass are
not centered vertically. The holes in the glass are 7 inches from the
intended bottom. When attaching the glass, make sure the
underside of the fireplace body is facing this intended bottom of
the glass.
Step 3
Insert transparent washers (Part F) into holes in
glass and using the screws (Part E) screw the glass to
the body. The screws attach to the support rod in the
underside of the fireplace so make sure these are all
in alignment.
Step 4
Repeat Step 3 for the second side, again keeping the
shorter distance of glass edge to the holes closer to
the bottom of the fireplace.
Publicidad
