Publicidad
Step 5
Attach clear rubber floor protectors (Part G) to
bottom the fireplace glass and turn it upright. If
rubber is longer than the glass, you can cut this
to length with a scissor. This is to help protect
the glass when standing.
Step 6
Insert burner in the rectangular recess in the center
of the fireplace frame.
NOTE: Your burner contains white fiberglass
wicking material inside it. Keep this in the
burner as it is intended for safety in the event
of a possible spill if the fireplace should ever
get tipped over. It will also make the flames
more consistent.
Step 7
It is highly recommended that you only use bottles with a flame
arrestor in the neck. Using the funnel provided (Part I), carefully pour
in the liquid ethanol fuel for fireplaces into the burner until it can
be seen above the perforated holes in the burner. If any fuel does spill,
you should always wipe it up prior to lighting your fireplace. Replace
cap on bottle and remove from area before lighting fireplace.
Step 8
Using a long lighter or long match, light the fuel in the burner
and ENJOY!
The handle provided (Part H) has holes that will fit over the posts on
the sliding lid of the burner. You can slide the lid of the burner open
or closed to get the desired flame height and heat output. When you
are ready to extinguish the fireplace, use the handle to slide the lid of
the burner completely closed to cut off the oxygen supply to the fuel.
This will snuff out the flame.
CAUTION: Fireplace will be hot while lit and may stay hot
for a while after extinguishing the flame.
ALWAYS USE CAUTION when lighting the fireplace.
NEVER fill the burner with more fuel while the fireplace is
still hot or burning. Allow it to cool down before refilling
with fuel.
Publicidad
