A - Things That Must Be Done Before Using Your Product And - Ugur UMD 200 HS Manual Del Usuario

A- THINGS THAT MUST BE DONE BEFORE USING YOUR PRODUCT
WARNING!
• Do not place your product to a place exposed to direct sunlight or influence area of the heat
sources such as stove, radiator core, oven, cooker, radiant and infrared. Otherwise, this may cause
performance decrease, damage of your product or make it become dysfunctional.
• Your product is set for operating at mains power of 220-240 Volt 50 Hz. Using your cooler with a
different voltage may cause it become dysfunctional and fire.
• Electrical installation must conform to national regulations.
• There must absolutely be a residual current relay and a fuse in your electrical installation for pre-
venting the risks of electrical shock and fire.
• Our company is not responsible for the failures and damage that may occur in case of using wit-
hout grounding.
• Place the product in a damp-free place with unobstructed air circulation.
• You must clean inside your product before the first use.
• After placing your product to its place, wait for one (1) hour without moving it before starting
using.
• If your product is installed under very cold weather conditions, then the waiting period must be
at least two (2) hours before starting to operate it.
• If you do not use your product for a short time or leave it empty, do not unplug it for saving
energy. Otherwise, more energy will be consumed for re-cooling your product.
• Unplug your product in case of sudden blackouts. For starting again, plug in your product 20 mi-
nutes after the electricity is supplied. High voltage occurring at the moment of electricity supply
may cause damage of your product and fire.
EN
• Do not allow wild animals and pets to enter into your product or walk around it. It may damage
your product or cause death and injury of the animals. Furthermore, wild animals and pets may
cause fire by giving harm to the electrical installation.
• Never place hot foodstuff into your cooler for cooling purposes.
• CL models of the product you have purchased, have been designed and manufactured for cold
storage of bottled, canned beverages and packed food and FR models have been designed and
manufactured for storing packed frozen food. Our company is not responsible for any damage
that may occur in the products that are used for another purpose.
• Your product is designed for using at indoor places. Do not use your product at outdoor places.
• Do not place materials that must not be cooled down into your product. Do not use your product
for defrosting frozen food.
• Product installation, placement, maintenance and cleaning must be done as stated in the manu-
al. Do not apply anything contrary to the manual. In case of any damage that may happen in your
product as the result of such use, warranty conditions will be invalid due to user error.
• In products, the doors of which are left opened or opened and closed continuously, frost deposit
will increase and no cooling operation will be carried out. Thus open the doors only when nee-
ded. Make sure that the doors are closed if not required.
• Your device does not have any sterilizing effect on the microorganisms. Therefore it is necessary
that the foodstuff you place into your product must conform to the hygiene standards. Otherwi-
se, microorganisms reproducing in foodstuff may pose a threat for your health.
34