Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
3.7 Personality
•
Enter the [PERSONALITY] mode to select DMX mode:
[TOUR] [TR16],
•
[ARC.1], [AR1.d], [AR1.S], [HSV]
3.8 Editing custom programs
•
Enter the [EDIT] mode to edit the custom programs
[PR.01] to [PR.10]
•
Each custom program has 30 steps that can be edited.
•
Each step allows the creation of a scene using RED [Red],
GREEN [Green], BLUE [Blue], STRB [Strb], TIME [Time] &
FADE [Fade].
3.9 Special settings
•
Elect [UPLD] to upload the custom programs from the
current MASTER unit to the SLAVE units.
•
In order to reset custom modes to default values se-
lect [REST].
•
[COLO] is for activate/unactivate the color calibration
functions. When [RGBW] is selected, on RGB=255,255,255,
the color is displayed as calibrated in CAL2 - RGBW. When
[COLR] is set [OFF], on RGB= 255,255,255, the RGB values
are not adjusted and the output is most powerful. When
PROTON IP
ENGLISH VERSION
[UC] is selected, the RGB output are adjusted to a stan-
dard preset universal color which balances fixtures from
different generations.
•
Select [DIM1], [DIM2], [DIM3] or [DIM4] for different dim-
ming speeds, ([DIM4] is the slowest dimming speed)
[CURV] allows the user to adjust the user to adjust the
shape of the dimming curve, See the CURV chart to un-
derstand more about actual dimming curves.
•
[DERR] Choose [Save] in order to save the last DMX data
incase of DMX signal error. Choose [Black] in order
•
to blackout in case of DMX signal error.
•
[SLCK] is used to lock the settings menu. When [SLCK]
is set to [ON] then user must insert passcode (UP-
+DOWN+UP+DOWN) in order to access the settings menu.
•
[STRB] This fixture allows for different strobe personal-
ity settings, [CLAS] strobe or [SPEC] strobe. The [STRB]
settings are only valid in the DMX personalities [TOUR],
[AR2.S] and [TR16]
CURV DIMMING
3.10 Balance parameters and correction
menu display
Press [MENU] button to enter the password confirmation, to
enter the correct password <UP + DOWN + UP + DOWN>
Key, press the [MENU] in, the correct password will enter
show submenu.
•
Enter the [CAL1] to select white color of different color
temperature.
•
There are 11 pre-programmed White colors can be edit-
ed by using [Red], [Green] & [Blue].
•
Enter the [CAL2] to adjust the RGB parameter to make
different whites.
•
When the new setting is activated, the DMX controller
p. 6
Publicidad
Tabla de contenido
