Description
1a Beard comb for trimming beard and short hair
1b Hair comb for cutting hair *
1c Release buttons for comb
2
Wide trimmer (32 mm)
3
Precision trimmer (16 mm) *
4
Release button precision trimmer *
5
Charge Indicator
6
Length selector
7
On/off switch
8
Special cord set
8a Charging stand
9
Pouch *
* not with all models
Charging
Recommended ambient temperature for charging is 5 °C to 35 °C.
The battery may not charge properly or at all under extreme low or high
temperatures. Recommended ambient temperature for shaving is 15 °C
to 35 °C. Do not expose the shaver to temperatures higher than 50 °C for
extended periods of time.
• Place the appliance (switched off) in the charging stand or connect it
directly to an electrical outlet via the special cord set (8).
• When charging for the first time or when the appliance is not used for
a few months, leave the appliance to charge continuously for 4 hours
(BT 3050cb: 8 hours).
• Once the appliance is completely charged, discharge it through normal
use. Then recharge to full capacity. Subsequent charges will take about
1 hour.
• A full charge provides up to 40 minutes of cordless operating time.
This may vary according to your beard growth.
• Maximum battery capacity will only be reached after several charging/
discharging cycles.
Charge Indicator (5)
BT 7050
• The charge indicator shows the status of the batteries.
• The charge indicator blinks green when the appliance is being charged.
When the battery is fully charged, the charge indicator shines permanently
green provided the appliance is connected to an electrical outlet.
12