Metra 99-7367 Instrucciones De Instalación página 4

1. Place the vent trim ring into the radio
housing trim panel and mount the vents
using the factory screws removed in
disassembly. Mount the clock and hazard
switch into the radio housing trim panel
using screws removed in disassembly.
(Figure A)
Note: If no factory clock is present,
a storage pocket and (4) # 8 x 3/8"
Phillips screws are provided.
2. Secure the start/stop switch or blank
plate depending on your application
into the radio housing trim panel.
Note: If no switch is present there are
(2) #8 X 3/8" Phillips screws supplied
to mount the blank plate.
3. Install the (8) panel clips removed in
disassembly onto the radio housing trim
panel.
Continue to Kit Assembly
4
KIT PREPARATION
(Figure A)
|
1.800.221.0932 MetraOnline.com