STACK-ON PC-650-B Manual De Instrucciones página 3

RECORDING FINGERPRINTS
For security you must record your fingerprint.
You can record up to 28 fingerprints
1. To record a fingerprint, press the Reset Button
(6). One "beep" will sound and the green light will
start to flash.
2. While the green light is flashing, slide a finger
across the scanner. When you hear a single "beep",
the scan has been successful.
Repeat scanning the same finger while listening for
the single "beep" for each successful scan. As you
continue to scan, the scanner is "learning" your
fingerprint. After a minimum of 5 scans and possibly
many more, the safe will eventually "beep" 2 times
indicating the fingerprint has successfully been
recorded.
If the finger scan happens to fail, the red light will
flash and there will be 4 "beeps". Continue to scan
after the green light goes on but be aware that 3
failed scans will result in the termination of the
recording session. You will then have to start over
from step 1.
3. Repeat steps 1 and 2 to record up to 28
fingerprints. If you try to record more than 28
fingerprints, the red light will flash and there will be
4 "beeps".
Reset Button
OPENING THE CASE USING A
RECORDED FINGERPRINT
1. Press the START button (2). There will be a one
"beep" and the green light will go on.
2. Slide a recorded finger across the scanner while
the green is on.
The scan has been successful if there are 2 "beep"
and the green light flashes. The case cover will open.
If the finger scan happens to fail, the red light will
flash and there will be 4 "beeps". Try to scan your
finger again after the green light goes on but be
aware that 3 failed scans will result in the scanner
shutting down. You will then have to start over from
step 1.
To close the case, push the cover closed until locked.
START button
3
18
40289-1307