Installing The Batteries - STACK-ON QAS-1810-B Manual De Instrucciones

INSTALLING THE BATTERIES

NOTE: Do not mix old and new batteries.
Do not mix alkaline, standard or
rechargeable batteries.
If your safe includes a shelf, remove it for better
access to the battery compartment. Push the
battery cover locking tab with a screwdriver to
release the cover. Install the (4) AA alkaline
batteries as shown. Replace the cover by
inserting the rear tabs in the slots and snapping
the cover in place.
NOTE: If the batteries are low the indicator light
will flash blue when you start scanning. Replace
with 4 new AA alkaline batteries as shown.
RECORDING FINGERPRINTS
When you first receive your safe there are no
recorded fingerprints. Any fingerprint will open
the safe until a fingerprint is recorded. For
security you must record a fingerprint. Failure to
do so will compromise the safety and security of
the safe. You can record up to 20 different
fingerprints for opening the safe. For best
results, each individual should use their thumb
or index finger only.
To record a fingerprint, first press the Reset
Button on the inside of the safe. The scanner will
light up with two beeps (if the sound is turned
on) and the blue light flashes twice, you will then
record the same finger three times as follows:
1. Place your finger on the scanner until there
is one beep (if the sound is turned on) and the
green light flashes once. Lift your finger off
the scanner.
2. Place the same finger on the scanner for a
second time, holding the finger in the same
position until there is one beep (if the sound is
turned on) and the green light flashes once.
Lift your finger off the scanner.
3. Place the same finger on the scanner for a
third time, holding the finger in the same
position until there is two beeps (if the sound is
turned on) and the green light flashes twice.
Lift your finger off the scanner. Your fingerprint
is now recorded.
SCAN THE SAME FINGER 3X
If the red light flashes three times with three
beeps (if the sound is turned on) your
fingerprint did not get recorded and you will
have to start over.
If you enter more than 20 fingerprints, the red
light will flash 5 times and there will be 5 beeps
(if the sound is turned on).
NOTE: In certain dry climate conditions, your
fingerprint may not scan. If your fingerprint did
not scan, we recommend moisturizing with
minimal lotion and trying again.
3
14
40789-1806