Preparation - Hoover 7122-01 Manual Del Usuario

Baño del ventilador con luz
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

PREPARATION

Before beginning assembly of product, make sure all parts are present. Compare parts with package
contents list and hardware contents. If any part is missing or damaged, do not attempt to assemble
the product. Contact customer service for replacement parts.
Estimated Assembly Time: 60 minutes
Tools Required for Assembly (not included): Hammer, Drill Bits, Flathead Screwdriver, Wire Nuts, Nails,
Duct Tape, Phillips Head Screwdriver, Utility Knife
Helpful Tools (not included): Electric Drill, Wood Screws
WARNING: Turn off electricity at breaker box before beginning installation.
Carefully remove unit from carton.
Check area above installation location to be sure that wiring can run to the planned location and that
duct work can be run and the area is sufficient for proper ventilation.
Inspect duct work and wiring before proceeding with installation.
Before installation, provide inspection and future maintenance access at a location that will not interfere
with installation work.
You may need the help of a second person to install this fan; one person on the attic side and one on
the room side.
Note: Installations may vary depending on how the previous bath fan was installed. Supplies necessary
for the installation of your bath fan are not all included; however, most are available at your local
home improvement or hardware store.
DIMENSIONS REQUIREMENTS
Ceiling
Opening (L)
Opening (W)
7-11/16 in.
WIRING DIAGRAM
LIGHT HOUSING
Up to 13 Watts
Capacitor for
motor
longlife of
motor
FAN HOUSING
www.homewerksww.com
Ceiling
Ceiling
Opening (H)
7-7/32 in.
5-1/8 in.
to 120V AC 60Hz
black
white
green
Junction box
to switch
to neutral
to switch
to neutral
to ground
5

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido