Preparation - Hoover 7125-02 Manual De Instrucciones

PREPARATION

WARNING: Turn off electricity at breaker box before beginning installation.
Carefully remove unit from carton.
Before beginning assembly of product, make sure all parts are present. Compare parts with package
contents list and hardware contents. If any part is missing or damaged, do not attempt to assemble
the product. Contact customer service for replacement parts.
Check area above installation location to be sure that wiring can run to the planned location and that
duct work can be run and the area is sufficient for proper ventilation.
Inspect duct work and wiring before proceeding with installation.
Before installaion, provide inspection and future maintenance access at a location that will not interfere
with installation work.
Do not attempt to install this fan in a wall or vaulted ceiling. This fan is for standard horizontal ceiling
installation only.
You may need the help of a second person to install this fan; one person on the attic side and one on
the room side.
Tools required for assembly (not included): Electric Drill, Drill Bits, Phillips Head Screwdriver, Utility Knife
Other supplies you will need (not included): Duct Tape, Wire nuts, 2 40Watt Candelabra Bulbs
Note: Installations may vary depending on how the previous bath fan was installed. Supplies necessary
for the installation of your bath fan are not all included; however, most are available at your local
home improvement or hardware store.
DIMENSIONS
Ceiling Ceiling Ceiling Body Body Body
Opening (L) Opening (W) Opening (H) Dimension (L) Dimension (W) Dimension (H)
9-5/16 in. 10-1/4 in. 6-1/4 in. 9-1/4 in. 10-1/8 in. 5-13/16 in.
5
www.homewerksww.com