Indication For Use; Intended Use; Equipment Setup And Use; Prior To Use - Skytron F-PTB2SKY Manual Del Usuario

INSTRUCTIONS FOR USE

Indication for use:

The Transfer Board is used in a variety of surgical procedures including, but not limited
to gynecology, urology, laparoscopy, general and robotic surgery. These devices
are capable of being used with a broad patient population as determined
appropriate by the caregiver or institution.

Intended use:

The Transfer Board is designed to support patient legs during transfer to the OR table
in a variety of surgical procedures including, but not limited to gynecology, urology,
laparoscopy, general and robotic surgery. These devices are intended to be used
by healthcare professionals within the Operating Room setting.
3

Equipment Setup and Use:

Prior to use:

a. Inspect the product looking for any visible damage or sharp edges that could
be caused by a drop or impact during storage.
b. Make sure product has been properly cleaned and disinfected and wiped dry
prior to each use.

Setup:

The side rail type of transfer board can be installed in place of the foot
section of the table or off of the head section. To install the side rail
transfer board, follow the instructions below:
1. Remove the leg section from
the table, if desired.
2. Align the blades on the transfer
board with the rails on surgical
table.
3. Tilt the transfer board.
4. Insert the blades on the transfer
board under the support on the
side rail of the surgical table.
5. Place the hooks over support
rails on the side rails.
Document Number: 80024535
Version: B
Hook
Page 11
Issue Date: 23 MAR 2020
Ref Blank Template: 80025118 Ver. E