Speed Control - ACME MW11 Manual De Instrucciones

GB
Installation
1. Plug the Nano receiver into a USB port of your computer.
2. Open the battery door and install batteries (2 X AAA).
Mouse Functions

Speed Control

Default DPI is 1000. If you want to change DPI, push right and left
keys together for 3 seconds. You can choose from these fixed DPI
values: 500; 1000; 1500; 1750.
Receiver Storage
Store or take out the Nano receiver from the Nano receiver storage
by push/pull the Nano receiver.
Trouble Shooting
1. Check Nano receiver connection; try to inserting Nano Receiver
to another USB port on your computer.
2. Connection between the mouse and the Nano Receiver. Re-
insert the Nano Receiver. Take out the battery and reinstall it.
Note
This device complies with Part 15 of the FCC rules. Operation is
subject to the following two conditions:
(1) This device may not cause harmful interference
(2) This device must accept any interference received, including
interference that may cause undesired operation.
4