CLEAN (ONE TOUCH CLEAN) OPERATION
Drying indoor heat exchanger after cooling operation to prevent mildew.
NOTE
When CLEAN operation finish, unit will switch OFF automatically.
●
If Weekly Timer or Once Timer is set, there is a need to cancel those timer before operating CLEAN function.
●
For multi connections, when pressing
●
For multi connections, when one room operates CLEAN operation first, other rooms can operate
●
COOLING, DEHUMIDIFYING or FAN operation. However, when other rooms need to operate HEATING
operation, air conditioner will be in STANDBY mode. After CLEAN operation finish, HEATING operation
will start.
■ To start CLEAN operation
Press
(CLEAN) button when unit is OFF.
●
Total time taken for One Touch Clean operation is 60 minutes.
During this operation, HEATING or FAN operation shall
1
operate.
During one touch clean, operation lamp is blinking.
"
", "
" is displayed on the LCD.
■ To cancel CLEAN operation
Press
(START/STOP) button.Or
●
Press
(CLEAN) button again.
●
(CLEAN) button, operation is limited to FAN operation.
– 2 0 –
– 20 –